Basic
POWERRESET
Basic Operation
Detaching the Front Panel" Controlable with Remote Control
(CDA-7873R only)
1Press and hold the POWER button at least 3This unit can be controlled with an optional
seconds to turn off the power.
Alpine remote control. For details, consult your
2Press the (Release) button at left side untilAlpine dealer.
the front panel pops out.Point the optional remote control transmitter at
3Grasp the left side of the front panel and pull itthe remote control sensor.
out.Remote control sensor
NOTES
" The front panel may become hot in normal usage
(especially the connector terminals on the back of the
front panel), this is not malfunction." Connectable to Remote Control Interface Box
" To protect the front panel, place it in the supplied
carrying case.You can operate this unit from the vehicle's
control unit when an Alpine Remote Control
Interface Box (optional) is connected. For
details, contact your Alpine dealer.
Attaching the Front Panel
Initial System Start-Up
1First, insert the right side of the front panel into
the main unit. Align the groove on the front panelImmediately after installing or applying power to the
with the projections on the main unit.unit, it should be initializRESETed. Press the switch
with a ballpoint pen or any other pointed object.
2Push the left side of the front panel until it locks
firmly into the main unit.
2
11
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
5-EN |