6. SUBW (Change the Subwoofer Phase):
Adjusting the built -in Audio
NOR ? REV
Processor
You can change the subwoofer phase.
(Only available when using the subwoofer output
You can change the Bass/Treble Frequencyfrom this unit.)
emphasis, High Pass Filter, Low Pass Filter7., andDEFP (Defeat On and Off):
Sub Woofer Phase on this unit, so that you canON ? OFF
create your favorite sound effects.When DEFEAT is turned ON, all items 1 to 6 are
set to default values.
When DEFEAT is turned OFF, all items 1 to 6
1Press the A.PROC button for at least 3 seconds
resume their last set values.
to enter Bass/Treble parameter setting mode.
Default values
2Within 5 seconds, press the DN g orBC: 80 Hz
f UP button repeatedly to select the desiredBW: WIDE1
parameter.TC: 10.0kHz
HP: OFF
? BC or BW ? TC ? HPLP: OFF
DEFP ? SUBW ? LP ?SUBW (Phase): NOR
Each time you press the MODE (Audio Control)NOTES
knob, the BC and BW change alternatery." If you turn the battery power OFF, all settings return
to factory default.
3Press the MODE (Audio Control) knob to toggle
" If HP, LP, BC, and TC are all set to ON, depending on
between the BC and BW.the BC and TC settings, you may not be able to
reinforce the sound effect.
1. BC (Setting the Bass Frequency):
" Except when the HP and LP is turned OFF, the
? 60Hz ? 70Hz ? 80Hz ? 90Hz
subwoofer is in monaural mode.
180Hz ? 150Hz ? 130Hz ? 100Hz ?" When the subwoofer is set to OFF, LP mode and
change of phase does not work.
Emphasizes the displayed Bass frequency" If no buttons are pressed within 5 seconds, the display
ranges.for setup menu disappears while an ordinary menu
appears on the display.
2. BW (Setting the Bass Band Width):
(Q-Factor)
? WIDE1 ? WIDE2 ? WIDE3 ? WIDE4Switching the Display Modes
(Narrow)? .................................? (Wide)
1Press the DISP (DISPLAY) button to select the
Changes the displayed frequencys band width
desired Display pattern mode.
to narrow or wide.
Each press changes the display patterns.
NOTE
A narrow or wide wave pattern on the display will
indicate the selected band width.Pattern Description
3. TC (Setting the Treble Frequency):1Frequency Pattern
? 10.0kHz ? 12.5kHz ? 15.0kHz ? 17.5kHz
2Normal Pattern (Upward)
3Peak Value Increasing Pattern
Emphasizes the displayed treble frequency
ranges.4Elevator (left/right) Pattern
4. HP (Setting the High Pass Filter):5Elevator (up/right) Pattern
? OFF ? 80Hz ? 120Hz ? 160Hz
6Warp Pattern
Outputs all frequencies higher than that selected7Center Division Pattern
according to your preference.
Scan Display
5. LP (Setting the Low Pass Filter):8(Repeats from Pattern 1 to Pattern 7
? OFF ? 160Hz ? 120Hz ? 80Hzfor every 5 seconds endlessly.)
9Mode Display
Outputs all frequencies lower than that selected
according to your preference.10Silent Display (Spectrum analyzer off)
(Only available when using the subwoofer output
from this unit.)
9-EN |